![]() | ||
Metropower Portal | ||
| ||
![]() Moderators: Jump to page : 1 2 Now viewing page 2 [25 messages per page] | |
Gallery-> Non Metro gallery | Message format |
dazz 111![]() |
| ||
![]() Extreme Veteran Posts: 592 ![]() ![]() ![]() ![]() Location: kent | Apparently all I'd need is a power commander and a decompression plate at 1.89mm thick...must finish the kit car first though | ||
dazz 111![]() |
| ||
![]() Extreme Veteran Posts: 592 ![]() ![]() ![]() ![]() Location: kent | cage is all in now, bit of a pain as I had to shorten the front section about 50mm to fit in, original seat belts don't fit so ill have to get some harnesses and remount the seats sprag clutch still needs fixing ![]() ![]() ![]() Edited by dazz 111 20/4/2015 6:57 PM | ||
dazz 111![]() |
| ||
![]() Extreme Veteran Posts: 592 ![]() ![]() ![]() ![]() Location: kent | neatened the switches and dash up today, and made the anti-tramp bars yesterday (finished in kingfisher blue so should add another 10bhp) ![]() ![]() ![]() ![]() | ||
Marv_666![]() |
| ||
![]() '88 MG METRO 1300 Posts: 1117 ![]() ![]() Location: Dudley, Midlands | Ditch the leaf springs and 6-link the back end!! Will find it behaves much better, and plenty of adjustment to get it spot on! Saw a Kitten out on the road the other day, fairly certain it was the first time!? Very faded dark red R-reg... instantly thought of this mad one and smiled!! | ||
dazz 111![]() |
| ||
![]() Extreme Veteran Posts: 592 ![]() ![]() ![]() ![]() Location: kent | Haha funny looking things arnt they plan is to get it in working state again then concerntrate on the kit car | ||
dazz 111![]() |
| ||
![]() Extreme Veteran Posts: 592 ![]() ![]() ![]() ![]() Location: kent | Haha funny looking things arnt they plan is to get it in working state again then concerntrate on the kit car | ||
dazz 111![]() |
| ||
![]() Extreme Veteran Posts: 592 ![]() ![]() ![]() ![]() Location: kent | Haha funny looking things arnt they plan is to get it in working state again then concerntrate on the kit car | ||
dazz 111![]() |
| ||
![]() Extreme Veteran Posts: 592 ![]() ![]() ![]() ![]() Location: kent | bit of painting ![]() ![]() ![]() ![]() ![]() | ||
Marv_666![]() |
| ||
![]() '88 MG METRO 1300 Posts: 1117 ![]() ![]() Location: Dudley, Midlands | Why so subtle?? Break out the masking tape, and give it FLAMES!!! | ||
dazz 111![]() |
| ||
![]() Extreme Veteran Posts: 592 ![]() ![]() ![]() ![]() Location: kent | i should paint it bright green realy but it would stick out like a sore thumb lol | ||
Marv_666![]() |
| ||
![]() '88 MG METRO 1300 Posts: 1117 ![]() ![]() Location: Dudley, Midlands | How about bright green AND flames? ![]() Better yet... tiger stripes!! (It being a Kitten that could rip your face off!?!) | ||
dazz 111![]() |
| ||
![]() Extreme Veteran Posts: 592 ![]() ![]() ![]() ![]() Location: kent | Haha ott i think ![]() | ||
Marv_666![]() |
| ||
![]() '88 MG METRO 1300 Posts: 1117 ![]() ![]() Location: Dudley, Midlands | What is the body and chassis alignment like on it? (Or what WAS it like?!!) I had a Scimitar SE6a that was shocking!! Another section of body laid up in the molds to lift the front corner where body was twisted... shims behind wishbones to put them in the right place... done from new at the factory too, not a bodge after repairs!! It wasn't subtle... but I bought it like this! ![]() | ||
dazz 111![]() |
| ||
![]() Extreme Veteran Posts: 592 ![]() ![]() ![]() ![]() Location: kent | No shims inbetween the body but there are shims in the wishbones and doors lol | ||
FreddieS![]() |
| ||
![]() Elf eating dog breeder Posts: 10531 ![]() ![]() ![]() ![]() Location: Guildford | Seen ya took it round lydden! Was in scotland at driftland that weekend, oh how I wish I couldve seen ya giving it death! How was it? | ||
dazz 111![]() |
| ||
![]() Extreme Veteran Posts: 592 ![]() ![]() ![]() ![]() Location: kent | Yeah, I loved it! Broke the car a bit but that's all part of being a novice The car done better then I thought it would Ps the barriers they put out are heavier than they look ![]() Edited by dazz 111 5/7/2015 10:02 PM | ||
Marv_666![]() |
| ||
![]() '88 MG METRO 1300 Posts: 1117 ![]() ![]() Location: Dudley, Midlands | dazz 111 - 5/7/2015 10:01 PM Ps the barriers they put out are heavier than they look ![]() Oh come on... you were in a Reliant... a traffic cone would probably have had the same effect!?! ![]() | ||
FreddieS![]() |
| ||
![]() Elf eating dog breeder Posts: 10531 ![]() ![]() ![]() ![]() Location: Guildford | dazz 111 - 6/7/2015 4:01 AM Yeah, I loved it! Broke the car a bit but that's all part of being a novice The car done better then I thought it would Ps the barriers they put out are heavier than they look ![]() I know, I wrote my bmw saloon off into one. Really annoys me as used to love Lydden before they put the rhino walls out, now it sucks because the best corner to throw big entries into is devils, so yeah, lets put 3 pissing rhino walls as close to the edge of the track as possible to really ruin your day. Glad it went well, videos it sounded good. now find me an rsv mille engine for my MG Midget, thanks! | ||
dazz 111![]() |
| ||
![]() Extreme Veteran Posts: 592 ![]() ![]() ![]() ![]() Location: kent | Don't see the purpose of them tbh, I'd rather hit the tyre wall, I'll be going again tomorrow, pop down to watch An Rsv engine would be a great fit in the midget...do it | ||
Jump to page : 1 2 Now viewing page 2 [25 messages per page] |
Printer friendly version E-mail a link to this thread Jump to forum : |
(Delete all cookies set by this site) | |
Running MegaBBS ASP Forum Software v2.0 © 2003 PD9 Software | |